EXOTRONIC Axion BatteryProduct Manual & Safety Notes For Exotronic Axion CANBus Bluetooth Lithium Batteries Includes standard caravan version and Marine Version notes Install by a competent person Use correctly rated cables, fuses, terminals and mounting hardware. Fuse the positive outputThe fuse must protect the cable and must not exceed 1.5C of the battery rated continuous current, and must protect the cables and equipment it is powering. Turn off before connection...

EXOTRONIC Axion BatterySafety Vent Installation Guide For Exotronic 12V 300Ah Axion CANBus Bluetooth Lithium Battery (Not applicable to the Marine Version) Use only 10 mm OD PTFE tube Cut square, push fully into the Axion vent fitting and support the tube. Maximum 1 m total tube length Keep the path short and direct from battery vent to outside. Outlet must be lower than the battery vent Route downward and avoid...

Notes & Limitations •    The State of Charge monitor cannot read current below ~1A and can drift out of several weeks of no use.  Complete a full charge cycle to re-calibrate•    After a trip, either press the On/Off/Reset Button twice to reset, or connect to a suitable power supply or charger to restart the BMS.•    After long periods of no use, or if continuously fast charging, the cells may get...

Notes & Limitations The State of Charge monitor cannot read current below ~1A and can drift out of several weeks of no use. Complete a full charge cycle to re-calibrate. After a trip, connect to a suitable power supply or charger to restart the BMS. After long periods of no use, or if continuously fast charging, the cells may get out of balance. The active balancer will correct this issue, to...

Notes & Limitations The State of Charge monitor cannot read current below ~1A and can drift out of several weeks of no use. Complete a full charge cycle to re-calibrate. After a trip, connect to a suitable power supply or charger to restart the BMS. After long periods of no use, or if continuously fast charging, the cells may get out of balance. The active balancer will correct this issue, to...

Notes & Limitations The State of Charge monitor cannot read current below ~1A and can drift out of several weeks of no use. Complete a full charge cycle to re-calibrate. After a trip, connect to a suitable power supply or charger to restart the BMS. After long periods of no use, or if continuously fast charging, the cells may get out of balance. The active balancer will correct this issue, to...